Facts You Should Know About Slab Leaks

Slab leaks refers to leaks of plumbing pipes which are installed in and or under the concrete slab foundation of your home. The signs for diagnosing a slab leak are a bit subtle, and slab leaks can be bothersome to repair, as they often require tearing up flooring to get to the source of the leak. In this article, I will present interesting facts about slab leaks for homeowners who are not familiar with the topic.

Reasons for installing underground piping: There are several reasons why builders prefer to install underground piping. First of all, it is cheaper to install copper pipes from the main line to the fixtures through an underground course. Less material will be required; there is no drilling, strapping of pipes to walls, and no need for installation of protection. Secondly, water lines running through the attic are subject to extreme temperatures. Hot water lines must be insulated to preserve heat in the winter, cold water lines have a difficult time preserving the temperature in the summer. Thirdly, water lines are liable to freeze and burst in the winter unless they are adequately insulated, as noted above, and this can be expensive to do.

There Are 4 Common Signs and Symptoms of a Slab Leak:

1. The initial symptoms might be a rising water bill and the sound of water running, like water in the toilet, when all the fixtures are shut down
2. Depending on whether it is a hot water or cold water leak, you might notice a hot spot or cold spot on your floor.
3. You might see visible wet spots in your basement or in your yard, around the house
4. If you try and listen through the lowest floor in your home, with a hollow steel pipe or a stethoscope, you might hear running water.

There are several important causes of slab leaks. Knowing the cause of the leak, might influence the type of repair that is recommended.

1. Incompatible soil causing a chemical reaction with the copper piping leading to corrosion and disintegration. If this is the cause of the leak, it will probably be advisable to change all the piping.
2. Improper wrapping of the pipes, when they were installed
3. Friction, which results from slight movements of the house, as it settles.
4. A kinked line, or one that was nicked by a workman during installation

What are the options for repairing a slab leak?

1. Occasionally, if positioned properly a piece of decaying pipe can be snatched from under the house and replaced, by working from the side of the house.
2. You can replace all of the underground piping. This is usually called for when the problem is incompatible soil.
3. You can run new piping above ground and simply short circuit the pipes running under the slab.

What are the reasons for installation of overhead piping?
1. They can be less expensive and more practical, if repair of the underground piping would involve tearing up something really valuable.
2. Rerouting works and is practical

What are the reasons why you wouldn't want to install overhead piping
1. Running overhead piping can diminish the estimated value of your home.
2. Overhead pipes can freeze and crack in the winter
3. A water leak on a concrete slab is better than a water leak on sheet rock, which drips down through the whole house.

These facts are meant to give you some understanding of slab leaks. If you actually have a slab leak, I would recommend contacting your plumber and getting his opinion.

Article Source: http://www.diyarticlelibrary.com

This article was brought to you by A-1 Plumbing of Baltimore. A-1 Plumbing of Baltimore is a Baltimore plumbing company that specializes in heating plumbing repair

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated